1998 Nissan Maxima Today Went Get Cars Check Engin Light Checked There Two Codes

1998 NISSAN MAXIMA
150,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
Today I went to get my cars check engin light checked there was two codes thrown the map sensor and a air intake temp sensor keep in mind car ran and drove fine before anything was done . I didn't get the air temp sensor yet but replaced map sensor after I replaced it I started car it idled great so I went to take for spin and and as soon as I hit accelerator I stalled out. I started back up idled fine I aggressively pressed accelerator this time managed to get rpm up to 2.5k but wouldn't go any further let off then I tried again lightly and stalled again I already cleaned maf sensor no luck. Any ideas as to what could've happened
Dec 1, 2012 at 9:53 PM
Advertisement
Avatar
DRCRANKNWRENCH
  • ✓Experienced Mechanic
  • 3,380 POSTS
You should install the intake temp snesor and run some wuality fuel system cleaner such as BG44K. Nothing else works like it. You wil have to go to a car dealerhhip parts department to get it and it $20.00 a bottle. Run 2 bottles on a full tank of gas each. You maaaaay notice some othe quirks withthe engnie as it works getting the deposits out. By the end of the thrid full tank you will notice the difference.
Dec 1, 2012 at 10:09 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.