1998 Mitsubishi Lancer transmission

1998 MITSUBISHI LANCER
2WD • AUTOMATIC
Avatar
JUNIOR DUNCAN
  • MEMBER
  • 3 POSTS
i have no drive,park or reverse light on the dash board and the car is stuck in 3 gear can hardly go up and hill ......................what can cause that problem?
Dec 8, 2014 at 11:09 PM
Advertisement
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
have a trans guy check this sounds like the trans is in limp mode so could be a switch or a rebuild may be needed.
Dec 8, 2014 at 11:27 PM
Avatar
JUNIOR DUNCAN
  • MEMBER
  • 3 POSTS
is there a specific switch that can cause that?
Dec 9, 2014 at 10:18 PM
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
no there are many sensors and solenoids in a trans along with the wiring could be the problem.
Dec 9, 2014 at 11:14 PM
Avatar
JUNIOR DUNCAN
  • MEMBER
  • 3 POSTS
ok thanks just gonna get it scan
Dec 10, 2014 at 12:53 AM
Avatar
RLIMBITCO
  • MEMBER
  • 1 POST
change the Neutral safety switch or others call it inhibitor switch, it is located on top of the trans and it is where the end of your shifter cable is connected and then check the fuse that correspond to this.
Jun 5, 2019 at 5:40 AM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle