1998 Mitsubishi Galant Mitshubishi Es S Also Manual Transmission Clutch 5

1998 MITSUBISHI GALANT
180,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
I have a 1998 Mitshubishi Galant ES.It's also a manual transmission/clutch 5 speed.And I'm trying to figure out what's wrong with it exactly.Everytime I go to drive it,& try to switch gears,it's like my gears completely freeze up,to where it will not go into any gear at all!So after about 10 minutes of sitting there,then the clutch finally starts working again!But I've noticed whenever the clutch starts to act up again to where I can't get it in any gears,my temperature gage goes down to cold.Then when I'm sitting there,waiting to be able to put the car I'm gear again,my temperature gage goes back up to normal again.What does my clutch have to do with my temperature gage??So what does it sound like the problem
may be to you??PLEASE HELP!!!I greatly appreciate any help!...............Thanks!
Nov 29, 2012 at 11:50 AM
Advertisement
Avatar
KHLOW2008
  • ASE Certified Mechanic
  • 41,814 POSTS
  • ASE Certified Mechanic
When you are not able to engage the gears, is clutch pedal low when pressure is felt?

Turn engine off. Engage 3th or 4th speed and start the engine with clutch pedal depressed. Ensure the parking and foot brake are applied and be prepared to turn engine off if necessary and nobody or anything is in front of vehicle.
Does vehicle seem to surge forward?
Try to disengage and engage a gear.

I don't see any relation between engine temperature and the clutch.


Nov 29, 2012 at 1:42 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.