1998 Mazda B2500 Might Clutch Won T Allow Transmission Engage Clutc

1998 MAZDA B2500
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
what might be the problem when the clutch won't allow the transmission to engage. The clutc pedal has no resistance and goes to the floor.
Dec 22, 2012 at 10:34 AM
Advertisement
Avatar
KHLOW2008
  • ✓Experienced Mechanic
  • 41,814 POSTS
Check the clutch fluid level. The hydraulic system has failed and either there is loss of fluids due to leaks or the master cylinder is bad.
Check for leaks in the system and if it is not very noticeable, top-up fluid, bleed system and recheck for leaks.
Dec 22, 2012 at 11:16 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.