mazda driveshaft

1998 MAZDA 323
85,000 MILES • 4 CYL • 2WD • MANUAL
Avatar
POCKETPOMS42
  • MEMBER
  • 1 POST
how do i remove inner cv tri-ball housing from the gearbox on mazda 323
Nov 22, 2010 at 11:03 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
KHLOW2008
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 41,814 POSTS
The Inner joint is plugged in and held inplace by a spring clip. You can use a pry bar to pry it out, unless youy have the special tool for pulling it out.

If it is too tight, a pry bar on each side of the joint would make it easier.
Nov 22, 2010 at 11:44 AM
Advertisement