oil change overfill

1998 JAGUAR XJ8
49,431 MILES • V8 • FWD • AUTOMATIC
Avatar
DLD
  • MEMBER
  • 2 POSTS
I had an oil change (car running fine prior) directly after the oil change car began to hesitate while driving then started to chug. I took to different shop because it was making very loud chugging sound and it would die when stopped etc.I was told they had overfilled by
1&3/4 quarts.
could this cause my car to have these problems plus front right cam problems? Thanks could really use your experienced thoughts on this. DLD
Jan 13, 2011 at 7:56 AM
Advertisement
Avatar
KHLOW2008
  • ASE Certified Mechanic
  • 41,814 POSTS
  • ASE Certified Mechanic
1.75 quart is rather a lot of oil to be overfilled and it can cause performance related problems but should not be related to cam problem.

Have the excess oil drained and retest.
Jan 13, 2011 at 12:59 PM
Avatar
DLD
  • MEMBER
  • 2 POSTS
thanks you. Today I was told by a Jag repair shop that it's most likely the variable timing, pushing tension out and left cam came in and right stayed out.
they are going to get back to me ( $234.??)later. They don't at this time think the oil over fill caused it. My other shop and every thing I read says that the overfill would cause damage.
I will get back to you when I know. Thanks, Don
Jan 13, 2011 at 9:24 PM
Avatar
KHLOW2008
  • ASE Certified Mechanic
  • 41,814 POSTS
  • ASE Certified Mechanic
Crankcase capacity is 6.9 quarts and 1.75 qts should not be too much as to cause problems to the engine but without any diagnostics, we would never know. Hope the Jag peopal can come up with an appropriate answer for you.
Jan 14, 2011 at 12:16 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.