I have 3 belts on the front of the engine the front one is about to break do not know what it is or how to change it.
Hope u can help also need help with oil filter change where is it.
Any diagram s would help too have been looking for two hours now and cant find what I am needing.
SPONSORED LINKS
Wednesday, June 26th, 2013 AT 1:40 PM
2 Replies
JACOBANDNICKOLAS
MECHANIC
109,645 POSTS
Based on which belt is bad will determine if you need to remove all three, two or just one of them. Look to see which it is. After that, it is just a matter or loosening the adjuster to remove the belt, replace it, and readjust. If you go to our homepage under the DIY section, there is a section with belt diagrams which you may find helpful.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Wednesday, June 26th, 2013 AT 7:11 PM
SEANGRANT00
MECHANIC
334 POSTS
It is a drive belt, you have to pull the belt tensioner to releve pressure on the belt and then replace. Where is the oil change? Find the drain plug, have something underneath to capture the oil, drain. Pull oil filter off, with oil filter pliers or a band wrench and let drain. Add drain plug back and with new oil filter, smear oil on the rubber gasket and screw back on. Add oil, start, check for oil pressure, and no leaks. Bingo.