How I can open the interior for wiring behind the number plate.
Feb 8, 2012 at 10:57 AM
Installing and wiring reversing camera on number plate.
1998 FORD FESTIVA
USPAK
- MEMBER
- 8 POSTS
Advertisement
MERLIN2021
- ✓ASE Certified Mechanic
- 17,250 POSTS
You need to wire the camera to the reverse light or the switch. Find the lights wire color, tap into it, and ground the ground the ground wire of your camera.
Feb 8, 2012 at 4:46 PM
How I can route the wire inside the body, How can open the interior of the boot door.
Feb 8, 2012 at 9:41 PM
CADIEMAN
- ✓ASE Certified Mechanic
- 3,544 POSTS
take the tag off look for screws.do u have a hatch back?
Feb 9, 2012 at 7:03 PM
It is a hatch back but I cannot see and tags or screws in the interior of the boot door.
Feb 9, 2012 at 8:07 PM
The part I want to open is called the Plastic trim inside the boor door. The problem is that I cannot see any tags, screws or friction pins. Thanks for all your help.
Feb 9, 2012 at 8:21 PM
MERLIN2021
- ✓ASE Certified Mechanic
- 17,250 POSTS
If there are no screws, there will be push pin type anchoring system for the trunk liner. Carefully pull out. Fish the wire around the back seat, remove the rocker panels and run the wire with the cars harness.
Feb 9, 2012 at 8:21 PM
Thank you, every one. I opened it. There are pins inside the panel, so you cannot see them. I just pulled it. To close it, I just need to press the panel on top of them
Feb 10, 2012 at 5:15 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.