M brake lights will not work when I press the brake and I have replaced the bulbs what else can the problem be
Feb 24, 2013 at 7:08 PM
1998 Ford Falcon M Brake Lights Will Work Press Replaced Bulbs Else
1998 FORD FALCON
ANONYMOUS
- MEMBER
- 1 POST
Advertisement
STOP LAMP SWITCH
Replace
The switch is located under the dash on the brake pedal mounting bracket.
1. Disconnect the wiring connector at the switch.
2. Remove brake pedal pivot bolt retaining clip.
3. Remove switch from pivot shaft, and install new switch assembly.
4. Install retaining clip to pivot shaft.
5. Reconnect the wiring connector.
6. Test stop light operation.
I also noticed on our car (AU series 3) that the cruise control would not engage.
Hope this is some help.
Tony
Replace
The switch is located under the dash on the brake pedal mounting bracket.
1. Disconnect the wiring connector at the switch.
2. Remove brake pedal pivot bolt retaining clip.
3. Remove switch from pivot shaft, and install new switch assembly.
4. Install retaining clip to pivot shaft.
5. Reconnect the wiring connector.
6. Test stop light operation.
I also noticed on our car (AU series 3) that the cruise control would not engage.
Hope this is some help.
Tony
Apr 23, 2013 at 4:55 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.