1998 Ford Explorer Serpentine Belt Keeps Falling Off Crankshaft Pulley Water

1998 FORD EXPLORER
80,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
The serpentine belt keeps falling off. The crankshaft pulley, water pump pulley, tensioner end pulley, and belt have been changed. The belt continues to fall off when the engine is running. What else can be wrong? I am stumped...
Nov 7, 2012 at 1:25 AM
Advertisement
Avatar
CJ MEDEVAC
  • ASE Certified Mechanic
  • 11,004 POSTS
  • ASE Certified Mechanic
YOUR TENSIONER MAY BE WORN--NO LONGER TENSIONS RIGHT

MAYBE A PULLEY IS NOT IN LINE (FLOPPY--INSTALLED WRONG)

DO ALL OF THE PULLEYS TURN FREELY W/ THE BELT OFF............EXCEPTION: CRANKSHAFT PULLEY

IF YOU HAVE A PULLEY THAT BOLTS ON----ARE THE BOLTS TIGHT?

DOES THE CLUTCH (INNER MOST PART OF THE A/C PULLEY) TURN FREELY W/ ENGINE OFF----ENGINE OFF---ENGINE OFF......USING YOUR FINGERS?

...........WHEN THE A/C OR DEFROST IS TURNED ON----THE CLUTCH ENGAGES THE A/C COMPRESSOR---BOTH SETTINGS USE THE COMPRESSOR

THE A/C CLUTCH PULLEY MAY TURN JUST FINE WITH IT FREEWHEELING........BUT WHEN YOU TURN ON THE A/C OR DEFROST-----IF THE COMPRESSOR IS "LOCKED UP" (BAD)----SUDDENLY THE PULLEY WON'T TURN------CAUSE IT'S NOW COUPLED TO THE PART UNABLE TO TURN.......THIS MAY SLING A BELT TOO!

THE MEDIC
Nov 7, 2012 at 1:46 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.