RUST

150,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
DMMURRY
  • MEMBER
  • 3 POSTS
i found out that my accumulator leaks in my 1998 Explorer. if i replace it, will it stop the leak? the problem is it rusted the base of the engine and frame....is the vehicle salvagable or should it be junked?
Jun 20, 2011 at 6:34 PM
Advertisement
Avatar
WRENCHTECH
  • ✓Experienced Mechanic
  • 20,760 POSTS
An accumulator is no big deal if you are sure that is the only problem. You will still have to do an evacuate and recharge to change it.
Jun 20, 2011 at 7:04 PM
Avatar
DMMURRY
  • MEMBER
  • 3 POSTS
?possibly something I can replace myself? The accumulator shows leakage and that's where the rust begins...and spreads like a virus
Jun 20, 2011 at 7:07 PM
Avatar
RIVERMIKERAT
  • ✓Experienced Mechanic
  • 6,106 POSTS
Without seeing the extent of the rust, that question can't be answered. Basically, if you can poke a screwdriver through the rusted section, that's a really bad problem. If the rust is just on the surface, use a rust converting polymer blend, such as Rust- to stop the rust and convert it to a paintable solid surface.
Yes, if the accumulator is leaking refrigerant, replacing it should fix the leak. As long as it is done properly.
Jun 20, 2011 at 7:10 PM
Avatar
WRENCHTECH
  • ✓Experienced Mechanic
  • 20,760 POSTS
A/C repairs are not generally DIY repairs. They require some expensive equipment to capture and recharge the refrigerant and knowledge to recognize issues and problems in the system.
Jun 21, 2011 at 2:43 AM
Avatar
DMMURRY
  • MEMBER
  • 3 POSTS
And my last q--- how do I know if the electric fuel pump is working if I pushed the reset fuel pump switch? I hear the engine and a small small 'putt'
Jun 21, 2011 at 11:32 AM
Avatar
RIVERMIKERAT
  • ✓Experienced Mechanic
  • 6,106 POSTS
Hook up a pressure tester at the fuel regulator. Many parts stores have loaner programs for tools.

Check out the attached image. In the power distribution box where the starter relay is located, you'll also find the fuel pump relay. Make sure the switching side of the relay is getting power and make sure it is receiving input power and switched (high current) power. Also, gain access to the top of the fuel tank and make sure the pump is receiving power.
Jun 21, 2011 at 12:16 PM
Avatar
RIVERMIKERAT
  • ✓Experienced Mechanic
  • 6,106 POSTS
"Done properly" pretty much sums up what you said, wrenchtech.
Jun 21, 2011 at 12:18 PM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle