Car engine

1998 DODGE STRATUS
17,000 MILES
Avatar
MUFTEEH
  • MEMBER
  • 48 POSTS
my dodge stratus, plug 1 and 3 use to soak fuel, after replacing the 2 nozzle and cylinder and valve was checked and tested with petrol it was noticed that everything was ok, after coppling the engine and was put to test the same problem still persists and the fuel consumption too high, pls , your professional advice is of big advantage to me .
Image (Click to enlarge)
Attached Media
Nov 20, 2011 at 10:08 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
Was the compression checked? Are you getting good spark to those cylinders? Is this the 2.5L v6?
Nov 21, 2011 at 4:52 AM
Advertisement
Avatar
MUFTEEH
  • MEMBER
  • 48 POSTS
yes that`s the pics of the car,the compression was checked and it seems a little bit ok today when I took it for a scan using OBDII Launch the code detected was P0108 (MAP sensor Voltage too high) and P1298 (slow change in MAP from start to run),I have tried to replace the MAP sensor but the second code is no clear to me,pls kindly be of help because the auto gear doesnt pick on time.
Nov 21, 2011 at 6:45 PM
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
If you replaced the map, check for resistance in wiring.
Nov 21, 2011 at 6:52 PM