tranny

150,000 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
GWEA2005
  • MEMBER
  • 9 POSTS
I just replaced both cv shafts and even replaced the replacements, there is a rattling in the transmission. I have the front end up on jack stands and when I put it in reverse the axels move with out the gas, but when i put it in drive there is nothing, even when i push the gas. the rattling only starts when I put it in any gear. I think its the transmission,and I was also wondering if replacing the cv shafts could have anything to do with this? Thanks
Apr 6, 2011 at 5:18 PM
Advertisement
Avatar
CARADIODOC
  • ✓Experienced Mechanic
  • 34,413 POSTS
An argument can be made for the new shafts causing or not causing the problem, but if neither wheel turns in drive there is something wrong in the transmission. First be sure both inner cv joints are fully seated in the transmission housing. If they are not, there should be a grinding noise in reverse AND in drive, but check that anyway.

One somewhat common problem is a broken small bolt in the differential part of the transmission that allows a larger pin to fall out of position. That larger pin will eventually back out far enough to catch on the housing and can break the housing. The wheels should still turn both ways until that pin hangs up.

If the rattling noise was there before you replaced the half shafts, there is something broken in the transmission. A transmission specialist should be able to give you a better idea on the best way to proceed.
Apr 6, 2011 at 8:43 PM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle