installing a new radio I touched the power cable to ground and it sparked now it wont' shift into overdrive

1998 CHRYSLER SEBRING
132 MILES
Avatar
MHAZELDINE
  • MEMBER
  • 1 POST
I recently installed my audio system in my car. Upon doing this when running the power cable I caused a ground and spark. When finishing the install I noticed that the SRS light is on now and the car will not shift into overdrive. Can you please help. I have a 98 Chrysler Serbing Coupe Lx
Nov 16, 2011 at 12:54 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
CARADIODOC
  • CAR REPAIR CONTRIBUTOR
  • 34,308 POSTS
Check the fuses in the car and under the hood. Typically the air bag system uses two fuses that might be inside yellow pull-handles on the end of the dash assembly. I think they're accessible after you open the driver's door.
Nov 16, 2011 at 1:05 AM
Advertisement