1998 Chrysler Concorde Intermittent jerking during deceleration

72,000 MILES
Avatar
BRANDON324
  • MEMBER
  • 1 POST
During car start up the car seems to idle rough but still idling just below 1000RPM, during acceleration there is sometimes a delay in responsiveness, but once the car has taken off and I am accelerating it seems to react normally, however during deceleration there is some fairly violent jerking. This is an intermittent problem and won't happen for weeks at a time and then it will occur again. Error code reads P1297. I recently replaced the MAP sensor, Camshaft Sensor and Crankshaft sensor to try to fix this problem, I replaced them about three weeks ago and had the problem reoccur so I'm back to the drawing board.
Oct 14, 2013 at 12:55 AM
Advertisement
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
check for a vacuum leak first use choke cleaner to spray around . then check for a restricted hose or soft hose going to map then wiggle test wires near map an dpcm where ever engine stalls then fix the harness/connectors. other than that have apro look at it.
Oct 14, 2013 at 2:29 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle