1998 Cirrus Tc 0122-0123

1998 CHRYSLER CIRRUS
158,000 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
TWJ69
  • MEMBER
  • 1 POST
I have 1998 Chrysler Cirrus LXI that is throwing TC's 0122-0123. I replaced the TPS and still get the same codes. Is there a short issue in the wiring harnass or a PCM issue? This is a 2.5l v6.
Jun 8, 2011 at 10:03 PM
Advertisement
Avatar
RASMATAZ
  • ✓ASE Certified Mechanic
  • 75,992 POSTS
  • ASE Certified Mechanic
Could be a power issue to the TPS, open,short and grounded circuit or the computer itself
Jun 8, 2011 at 10:06 PM
Avatar
CARADIODOC
  • ✓ASE Certified Mechanic
  • 34,321 POSTS
  • ASE Certified Mechanic
Measure the voltages on the three throttle position sensor wires. They should be 5.0 volts, 0.2 volts, and the middle one will have between 0.5 and 4.5 depending on throttle position. You'll have to back-probe them through the connector. The readings have to be taken while it is still plugged in.
Jun 8, 2011 at 10:47 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.