won't engage
lights flash on selector switch
lights flash on selector switch
Feb 13, 2011 at 3:23 PM
diagnostics 4x4 system for a 1998 Chevy s-10 pick up
1998 CHEVROLET S-10
CHERYL DURAN
- MEMBER
- 1 POST
Advertisement
FIXITMR
- ✓ASE Certified Mechanic
- 9,990 POSTS
First check fuses. Next replace the transfer case switch it is located in front of the transfer case it has two wires on it. They go all the time. next check for vacuum lines. They run off your cruise control reservoir to a vacuum switch near the firewall and then to the 4wd diaphragm . This diaphragm is located under the battery. You must remove the battery tray to get to it. It sometimes rips. If I were a betting man I'd go with the transfer case switch.
did ya get er fixed?
did ya get er fixed?
May 12, 2011 at 8:14 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.