Where is the cam shaft position sensor located and how to replace it on a 1998 Chevrolet Lumina, 3.1 engine
Feb 10, 2011 at 7:41 PM
cam shaft position sensor
CURT7806
- MEMBER
- 1 POST
REMOVAL PROCEDURE
Disconnect the negative battery cable.
Remove the serpentine drive belt.
Remove the power steering pump.
Remove the electrical connector.
Remove the bolt.
Remove the sensor.
INSTALLATION PROCEDURE
Install the Camshaft Position Sensor.
Tighten
*Retaining bolt to 10 Nm (8 lb. ft).
Install the electrical connector.
Install the power steering pump.
Install the serpentine drive belt.
Connect the negative battery cable.
Disconnect the negative battery cable.
Remove the serpentine drive belt.
Remove the power steering pump.
Remove the electrical connector.
Remove the bolt.
Remove the sensor.
INSTALLATION PROCEDURE
Install the Camshaft Position Sensor.
Tighten
*Retaining bolt to 10 Nm (8 lb. ft).
Install the electrical connector.
Install the power steering pump.
Install the serpentine drive belt.
Connect the negative battery cable.
Image (Click to enlarge)
Feb 10, 2011 at 9:54 PM