cam shaft position sensor

1998 CHEVROLET LUMINA
800,000 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
CURT7806
  • MEMBER
  • 1 POST
Where is the cam shaft position sensor located and how to replace it on a 1998 Chevrolet Lumina, 3.1 engine
Feb 11, 2011 at 3:41 AM
Advertisement
Avatar
RASMATAZ
  • ✓ASE Certified Mechanic
  • 75,992 POSTS
  • ASE Certified Mechanic
REMOVAL PROCEDURE
Disconnect the negative battery cable.
Remove the serpentine drive belt.
Remove the power steering pump.
Remove the electrical connector.
Remove the bolt.
Remove the sensor.

INSTALLATION PROCEDURE

Install the Camshaft Position Sensor.

Tighten
*Retaining bolt to 10 Nm (8 lb. ft).
Install the electrical connector.
Install the power steering pump.
Install the serpentine drive belt.
Connect the negative battery cable.

Image (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Feb 11, 2011 at 5:54 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.