Neutral safety switches come in 2 different types. See Fig. 16. Ensure shift cable is adjusted. To adjust switch, place gear selector lever in Neutral.
Place transaxle lever in Neutral detent. Loosen switch attaching screws. Rotate switch on shifter assembly to align adjustment hole with carrier tang hole.
Insert a.094" (2.4 mm) wire gauge about 5/8" (16 mm) into switch holes. Tighten attaching screws. Remove wire gauge. New switches may have a plastic pin installed in hole. Plastic pin is designed to shear off during initial shift lever operation.
Fig. 16: Adjusting Park Neutral Position (PNP) Switches (FWD)
Image (Click to make bigger)
Wednesday, January 5th, 2011 AT 9:56 AM