cann't get stater out from eng. & frame

1998 CHEVROLET BLAZER
102,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
MIKERITCHIE
  • MEMBER
  • 4 POSTS
how too remove stater from eng. & frame of 1998 chev. blazer 4x4
Jan 31, 2011 at 5:44 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JDL
  • CAR REPAIR CONTRIBUTOR
  • 16,098 POSTS
If the info below doesn't help, I'd have to look at it.
Jan 31, 2011 at 6:01 PM
Advertisement
Avatar
MIKERITCHIE
  • MEMBER
  • 4 POSTS
I can,t get the stater back in vehicle i pull the eng. too do the bottom end had too pull stater win eng. was up out off motor mounets
Jan 31, 2011 at 6:17 PM
Avatar
JDL
  • CAR REPAIR CONTRIBUTOR
  • 16,098 POSTS
Without being able to look at it, I'm not sure what to tell you. Can you use engine hoist without hurting anything, to give you more room?
Jan 31, 2011 at 6:59 PM
Avatar
MIKERITCHIE
  • MEMBER
  • 4 POSTS
I had too remove the eng. mounts.
Feb 1, 2011 at 5:19 PM
Avatar
JDL
  • CAR REPAIR CONTRIBUTOR
  • 16,098 POSTS
Hope you got it going your way.
Feb 1, 2011 at 5:48 PM