1998 ACURA EL
180,000 MILES
Avatar
CARGOINT
  • MEMBER
  • 2 POSTS
How can i change bulb in rear dashboard mounted brake light ?
Nov 15, 2012 at 1:56 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
KHLOW2008
  • CAR REPAIR CONTRIBUTOR
  • 41,814 POSTS
Open trunk and look under the spot where the high mount brake light is. The bulb socket should be inside a hole on the panle. Twist the socket counterclockwise and pull it out. Bulb is plugged into socket.
Image (Click to enlarge)
Attached Media
Nov 15, 2012 at 6:08 PM
Advertisement
Avatar
CARGOINT
  • MEMBER
  • 2 POSTS
I TRIED HARD WITH HAND TO TWIST THE SOCKET COUNTERCLOCKWISE BUT COULD NOT SUCCEED EVEN MY HAND WAS NEAR TO GET INJURED. IT DID NOT GET TWISTED, JUST SLIGHTLY MOVED ALMOST NONE. NOR I COULD DETACH THE WIRE CONNECTOR/ CLIP. PLEASE COMMENT. I WOULD BE THANKFUL
Dec 15, 2012 at 9:22 PM
Avatar
KHLOW2008
  • CAR REPAIR CONTRIBUTOR
  • 41,814 POSTS
Use a long nose plier to assist. Do not force too hard. Space is tight so a little wiggling is required.
Dec 16, 2012 at 6:51 AM