on acceleration car will not go over 20 miles per hour and engine revs up and down

1998 ACURA CL
186,000 MILES
Avatar
FRANK2888
  • MEMBER
  • 2 POSTS
Car starts and idles ok...fuel filter replaced....fuel pressure regulater replaced...could it be pump
Mar 25, 2012 at 1:43 PM
Advertisement
Avatar
DRCRANKNWRENCH
  • ASE Certified Mechanic
  • 3,380 POSTS
  • ASE Certified Mechanic
Here is a walk through diagnostic for your su=ituation. Just follow the links below;

https://www.2carpros.com/articles/engine-surges
Mar 25, 2012 at 2:45 PM
Avatar
JACOB4JC-ACURACL-98-2.3
  • MEMBER
  • 1 POST
check timing. your car is in limp mode or aka safe mode and my car was in the same thing and mechanic checked timing and it was off a little. also other reasons could be airflow. something with exhaust, vacuum, or intake one of the those or more than likely the reason for safe mode. safe mode is when your computer senses something isnt right and it wont let you blow up your motor
Jul 12, 2012 at 5:32 PM
Avatar
DRCRANKNWRENCH
  • ASE Certified Mechanic
  • 3,380 POSTS
  • ASE Certified Mechanic
You could have a clog in the intake or exhaust. Sometimes the catalytic converters fail and fall in on themsleves. You can do a quick check, this is not fir sure it is bad, by smacking ti with a rubber amllet or your hand and listening for loosee material. Remember you have more than one in some applications.
A large vacuum leak would also cause this behaviour and it should be something you can hear with the engine running and the hood open.
Jul 12, 2012 at 8:06 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.