rover 100 metro

1997 ROVER 100
4 CYL • FWD • MANUAL
Avatar
ADI. METRO
  • MEMBER
  • 1 POST
how do i remove the thermostat housing on a 1997 rover 100 1.1?
Mar 20, 2011 at 6:01 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RIVERMIKERAT
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 6,110 POSTS
the thermostat is located at the rear of the engine under the inlet manifold. There is a metal pipe which runs along the back of the engine and enters the main block on the left side. The pipe has two securing bolts, bolted to the engine block. follow this pipe towards the cambelt (left) this pipe leads to the thermostate housing. It is secured by three 8mil bolts. remove these also the two securing bolts and pull to the right the pipe will seperate and the thermostat is located.
Jun 19, 2011 at 8:59 PM
Advertisement