1997 Plymouth Breeze Runs Great Cold Warms Dies Clutch Pushed Replaced Fuel

1997 PLYMOUTH BREEZE
205 MILES
Avatar
SHANNONLTIETZ
  • MEMBER
  • 3 POSTS
Runs great cold, when it warms up it dies when clutch is pushed in.replaced fuel pump, filter, cleaned throttle body, codes 11, 21&15 come up....where do I start?
Jan 6, 2013 at 2:22 AM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
Code 11 The engine has not cranked since the battery was disconnected.

Code 15 No signal received by the computer (ECU) from the speed sensor

Code 21 Oxygen sensor reporting too lean or too rich after 2 – 12 minutes with temp over 170° and RPM above 1500

I have to be honest, I don't see any of those codes causing it to die when you push in the clutch. Have you checked for vacuum leaks? That can cause the stall and a lean mixture. Also, check the idle air control valve (IAC)

Jan 6, 2013 at 2:28 AM
Avatar
SHANNONLTIETZ
  • MEMBER
  • 3 POSTS
I can't find any vaacum leaks anywhere, will check the iac valve in the am.anything I should look for?
Jan 6, 2013 at 4:04 AM
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
Just make sure it is moving when you turn the key on and off.
Jan 6, 2013 at 4:08 AM
Avatar
SHANNONLTIETZ
  • MEMBER
  • 3 POSTS
Will do..I'll get back to u
Jan 6, 2013 at 4:10 AM
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
I'll be looking for your reply
Jan 6, 2013 at 4:30 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.