How to check the crankshaft sensor for montero mitsubishi engine 3.0 12 valves.
Apr 11, 2011 at 10:47 PM
the engine did not have spark
JOSE BRANDI
- MEMBER
- 15 POSTS
Advertisement
Check the resistances of the CPS and also the gap/alignment
Apr 12, 2011 at 4:28 AM
I check the CKP sensor's resistance, the reading in the voltimeter is over range of ohms (1.). This means that the CKP sensor is open of shorted? No codes in the PCM. No RPM is detected (0 RPM) in the scanner during the crank.
The primary hardness connector of the ignition coil have 11.5 V, but no spark is generated to the distrubutor. Could be defective ignition coil?
The primary hardness connector of the ignition coil have 11.5 V, but no spark is generated to the distrubutor. Could be defective ignition coil?
Apr 13, 2011 at 11:23 PM
Any else have an answer for this.
Thanks
Thanks
Apr 16, 2011 at 9:30 PM
Hi,
The problem of no spark was due to open (defective) CKP.
The problem of no spark was due to open (defective) CKP.
Jun 9, 2012 at 8:20 PM
Thanks for the comeback and Good Luck
Jun 9, 2012 at 8:56 PM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement
parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.