1997 626 ENGINE CRANK WITH SPARK BUT WILL NOT RUN, AMPLE FUEL PRESSURE, BATTERY WENT DEAD AND REPLACED WHICH CLEARD ECM MEMORY.
Nov 17, 2010 at 8:04 AM
Advertisement
MMPRINCE4000
✓Experienced Mechanic
8,548 POSTS
Spray starting fluid in intake while cranking, if engine runs a few seconds, then ignition problem, otherwise a spark issue.
Nov 17, 2010 at 8:10 AM
KHLOW2008
✓Experienced Mechanic
41,812 POSTS
Try some starting fluid and if it starts, check the fuel injectors for battery voltage supply and pulsing.
Nov 17, 2010 at 8:10 AM
AITCH1
MEMBER
3 POSTS
WILL NOT START, ECM DID NOT READ CAM SIGNAL AFTER BATTERY CHANGED, THERE FOR NO BASE LINE, ALSO DISCONNECTED O2 SENSOR AND CRANKED NO DTC FOUND.
Nov 17, 2010 at 8:48 AM
RASMATAZ
✓Experienced Mechanic
75,988 POSTS
The eyeball and thumb method is not gonna work with the fuel pressure -you need to use a fuel pressure tester to determine the actual fuel pressure the fuel pump is producing, also check if the injectors are pulsing meaning if its opening and closing to provide fuel to the cylinders