My 1997 Mazda 626 with 2.0 4cyl. runs fine until engine is warm, then starts to sputter when accelerating and will stall when stopping.
Feb 16, 2011 at 4:00 AM
1997 Mazda 626 is sputtering and stalling when accelerating after engine warms
1997 MAZDA 626
AUGOPHER
- MEMBER
- 1 POST
- FOLLOW
Advertisement
Do you have a check engine light on and when was the last tune-up?
Lack of acceleration,chugging,hesitating********,bogging,misfiring etc. could be caused by one of the following below
Oxygen sensor.
Catalytic converter.
Fuel injectors dirty/sticking.
Mass airflow sensor/Airflow meter.
Throttle position sensor.
Crankshaft position sensor
Knock sensor
Manifold absolute pressure sensor.
EGR Valve
Fuel pressure regulator leaking or defective fuel pump.
Fuel contamination.
Foul/defective spark plugs.
Open spark plug wires.
Ignition coil/Coil packs defective.
Incorrect ignition timing.
Cap and rotor.
Note:If it doesn't apply disregard it and keep testing.
Lack of acceleration,chugging,hesitating********,bogging,misfiring etc. could be caused by one of the following below
Oxygen sensor.
Catalytic converter.
Fuel injectors dirty/sticking.
Mass airflow sensor/Airflow meter.
Throttle position sensor.
Crankshaft position sensor
Knock sensor
Manifold absolute pressure sensor.
EGR Valve
Fuel pressure regulator leaking or defective fuel pump.
Fuel contamination.
Foul/defective spark plugs.
Open spark plug wires.
Ignition coil/Coil packs defective.
Incorrect ignition timing.
Cap and rotor.
Note:If it doesn't apply disregard it and keep testing.
Feb 16, 2011 at 4:31 AM