Friday, April 1st, 2011 AT 7:55 PM
TOMMIEK
- MEMBER
- 1997 MAZDA 626
- 6 CYL
- 2WD
- MANUAL
- 170,000 MILES
Replace front disc pads
Mazda 626 2.5l
1 Reply
KHLOW2008
- MECHANIC
- 41,814 POSTS
Removal & Installation
1. Raise and support front of vehicle. Remove front wheel assemblies. Remove lower lock pin/guide bolt. Pivot caliper upward and support using a hanger.
2. Remove pads, shims, guide plates or pad guides and "V" springs.
3. To install, reverse removal procedure. Use a G-clamp and an old pad to push piston fully inward to install disc pads.
1. Raise and support front of vehicle. Remove front wheel assemblies. Remove lower lock pin/guide bolt. Pivot caliper upward and support using a hanger.
2. Remove pads, shims, guide plates or pad guides and "V" springs.
3. To install, reverse removal procedure. Use a G-clamp and an old pad to push piston fully inward to install disc pads.
Image (Click to make bigger)
SPONSORED LINKS
Was this helpful?
Yes
No
Friday, April 1st, 2011 AT 9:03 PM
Related Brake Rotor Replace/Remove Content
Sponsored links
SPONSORED LINKS
Wheel Bearing Replacement
