1997 Jeep Laredo Bad ignition switch

1997 JEEP GRAND CHEROKEE LAREDO
196,000 MILES • 4.0L • 6 CYL • 4WD • AUTOMATIC
Avatar
LARRYPALMER
  • MEMBER
  • 1 POST
Cranks but wont run sometimes, on/off instrument lights, runs good when runs, computer, coil, plugs,cap&rotor, vacuum,all good. suspect is bad ignition switch. Can I hot wire ignition to test circuit? Is there a way?
Dec 11, 2015 at 5:11 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
no don't hotwire try resetting security system first. then check wiring harness at rear of engine to see if it has worn through. that is a problem with older jeeps with 4.0L. it's by the stud in head.
Dec 12, 2015 at 11:30 AM
Advertisement