how to change window motor in jeep
Aug 18, 2011 at 7:12 AM
jeep window motor
1997 JEEP CHEROKEE
KNIPE_92
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
POWER WINDOW MOTOR
NOTE:Power window motor and mechanism is integral to power window regulator. If power window motor or mechanism is faulty, window regulator assembly must be replaced.
Removal & Installation (Front Window Motor)
Disconnect negative battery cable. Remove front door trim panel. See DOOR TRIM PANEL . Pry up on weatherstrip corner and remove inner and outer weather-stripping. See Fig. 4 . Put window in up position.
Remove bolts securing glass to regulator assembly. Carefully lift glass upward and out of door. Loosen regulator assembly mounting bolts/nuts. See Fig. 5 .
Lift regulator assembly upward to release assembly from key hole slots. Remove regulator assembly through access hole in inner door panel. To install, reverse removal procedure.
NOTE:Power window motor and mechanism is integral to power window regulator. If power window motor or mechanism is faulty, window regulator assembly must be replaced.
Removal & Installation (Front Window Motor)
Disconnect negative battery cable. Remove front door trim panel. See DOOR TRIM PANEL . Pry up on weatherstrip corner and remove inner and outer weather-stripping. See Fig. 4 . Put window in up position.
Remove bolts securing glass to regulator assembly. Carefully lift glass upward and out of door. Loosen regulator assembly mounting bolts/nuts. See Fig. 5 .
Lift regulator assembly upward to release assembly from key hole slots. Remove regulator assembly through access hole in inner door panel. To install, reverse removal procedure.
Aug 18, 2011 at 11:49 AM
Advertisement