Crankshaft Pulley!!!!!!!!!!

1997 ISUZU RODEO
6 CYL • 4WD • MANUAL
Avatar
JORDASH
  • MEMBER
  • 1 POST
Do you need a special tool to take the crankshaft pulley off the crankshaft?
Jan 5, 2011 at 9:39 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
DOCFIXIT
  • CAR REPAIR CONTRIBUTOR
  • 18,828 POSTS
A three arm puller will remove
Jan 5, 2011 at 9:42 PM
Advertisement
Avatar
SATURNTECH9
  • CAR REPAIR CONTRIBUTOR
  • 30,869 POSTS
You need a strong impact gun or the holding tool for the crankshaft to break it loose.Unless you can use a big pry bar to hold it in place on the flywheel ring gear.
Jan 5, 2011 at 9:45 PM
Avatar
SATURNTECH9
  • CAR REPAIR CONTRIBUTOR
  • 30,869 POSTS
That's for the bolt anyways but the 3 arm puller with get the pulley off like Docfixit said.
Jan 5, 2011 at 9:57 PM