Aligning timing marks

Tiny
SATURNER2010
  • MEMBER
  • 1997 ISUZU RODEO
  • 6 CYL
  • 2WD
  • AUTOMATIC
  • 178,000 MILES
Changing water pump and timing belt. Can't get the old belt marks (original-intact) to line up with the marks on the pulleys according to manual diagram. Do I keep turning the crankshaft clockwise until all the marks line up?
(Core problem is with the water pump) Vehicle runs.
Wednesday, July 27th, 2011 AT 8:49 PM

1 Reply

Tiny
KASEKENNY
  • MECHANIC
  • 18,907 POSTS
I am attaching the process below on how to replace the water pump just in case you need this info as well.

Also, here is a guide that will help with replacing the belt as this contains some good general info:

https://www.2carpros.com/articles/serpentine-belt-timing-belt-timing-chain-diagrams

Also, below are the timing marks you need to make sure are lined up. You need to turn the engine in the direction that the crank spins so you can pump it over and confirm this is clockwise, but I am pretty sure it is.

So, you may be checking this number 1 is not on TDC, so the marks are not going to line up.

However, just to be clear if the engine runs, is there a reason you are trying to get the marks to line up?
Was this
answer
helpful?
Yes
No
Sunday, March 20th, 2022 AT 7:50 PM

Please login or register to post a reply.

Sponsored links