is there a shim plate between the flywheel and the crankshaft?

1997 HONDA DEL SOL
Avatar
BRAD.QUEENAN
  • MEMBER
  • 2 POSTS
the motor runs fine. the transmission shifts but the car doesn't move.
May 13, 2012 at 5:47 AM
Advertisement
Avatar
ASEMASTER6371
  • ✓Experienced Mechanic
  • 52,796 POSTS
no, there is a washer on the other side and has no efect on your issue. it sounds like you have a failed pressure plate.
Roy
May 13, 2012 at 6:18 AM
Avatar
BRAD.QUEENAN
  • MEMBER
  • 2 POSTS
but i just bought a brand new one from napa yesterday. And i assembled with both the new pressure plate, as well as the old one, and neither works. is there any thing else you can think of?
May 13, 2012 at 6:30 AM
Avatar
ASEMASTER6371
  • ✓Experienced Mechanic
  • 52,796 POSTS
the old one?? old what??
Is the slave cylinder moving the throwout bearing at all??

Roy
May 13, 2012 at 6:46 AM
Avatar
KHLOW2008
  • ✓Experienced Mechanic
  • 41,814 POSTS
Are the axle shafts installed correctly?
Was the transmission tested to be good?
May 13, 2012 at 9:25 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.