the motor runs fine. the transmission shifts but the car doesn't move.
May 13, 2012 at 12:47 PM
is there a shim plate between the flywheel and the crankshaft?
1997 HONDA DEL SOL
BRAD.QUEENAN
- MEMBER
- 2 POSTS
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
no, there is a washer on the other side and has no efect on your issue. it sounds like you have a failed pressure plate.
Roy
Roy
May 13, 2012 at 1:18 PM
Advertisement
but i just bought a brand new one from napa yesterday. And i assembled with both the new pressure plate, as well as the old one, and neither works. is there any thing else you can think of?
May 13, 2012 at 1:30 PM
the old one?? old what??
Is the slave cylinder moving the throwout bearing at all??
Roy
Is the slave cylinder moving the throwout bearing at all??
Roy
May 13, 2012 at 1:46 PM
Are the axle shafts installed correctly?
Was the transmission tested to be good?
Was the transmission tested to be good?
May 13, 2012 at 4:25 PM