How do i locate and remove the slave cylinder?

1997 HOLDEN VECTRA
Avatar
HIWITOMARS
  • MEMBER
  • 2 POSTS
i need to replace the slave cylinder and i cannot locate its actual position.
Dec 12, 2011 at 4:45 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RIVERMIKERAT
  • CAR REPAIR CONTRIBUTOR
  • 6,110 POSTS
It's on the side of the transmission. It has a steel line/tube going to it.
Dec 12, 2011 at 5:02 AM
Advertisement
Avatar
HIWITOMARS
  • MEMBER
  • 2 POSTS
97 holden vectra, manual gearbox?????????????
Dec 12, 2011 at 7:05 AM
Avatar
RIVERMIKERAT
  • CAR REPAIR CONTRIBUTOR
  • 6,110 POSTS
Yes, automatic transmissions don't have clutches that are actuated by a pedal.

Removal is normally a matter of removing nuts and bolts after releasing the hydraulic pressure by opening a bleeder screw on the slave cylinder.
Dec 12, 2011 at 7:38 AM
Avatar
MHPAUTOS
  • CAR REPAIR CONTRIBUTOR
  • 31,937 POSTS
Depending on the model it may be an internal slave cylinder, if there is no sign of it externally, it will be internal and the box will have to come out to replace it.
Dec 12, 2011 at 9:55 PM
Avatar
RIVERMIKERAT
  • CAR REPAIR CONTRIBUTOR
  • 6,110 POSTS
And enter the Aussie and Brit vehicle expert. Thanks mhpautos.
Dec 13, 2011 at 1:38 AM
Avatar
MHPAUTOS
  • CAR REPAIR CONTRIBUTOR
  • 31,937 POSTS
Takes a bow and exits stage right...........
Dec 13, 2011 at 5:08 AM