obd-2 port isn;t linking to eec unit

1997 FORD TAURUS
65,000 MILES
Avatar
CHRIS ROBINANDPOOH
  • MEMBER
  • 8 POSTS
what do I do in this case ?
Mar 18, 2012 at 3:50 AM
Advertisement
Avatar
FIXITMR
  • CAR REPAIR CONTRIBUTOR
  • 9,990 POSTS
could be a fuse or bad connection
Mar 18, 2012 at 4:02 AM
Avatar
FIXITMR
  • CAR REPAIR CONTRIBUTOR
  • 9,990 POSTS
also is scanner powered or does it need port for power?
Mar 18, 2012 at 4:05 AM
Avatar
CHRIS ROBINANDPOOH
  • MEMBER
  • 8 POSTS
all fuses under dash good power block fuses all good too, unit is powering up and then reads error. whats next?
Mar 18, 2012 at 4:15 AM
Avatar
FIXITMR
  • CAR REPAIR CONTRIBUTOR
  • 9,990 POSTS
check engine light works?
Mar 18, 2012 at 4:21 AM
Avatar
CHRIS ROBINANDPOOH
  • MEMBER
  • 8 POSTS
I'm not sure I'll check in the morning . It was a total long block swap and it went really easy , too easy . I dont know if it helps or matters .
Mar 18, 2012 at 7:25 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.