obd-2 port isn;t linking to eec unit

1997 FORD TAURUS
65,000 MILES
Avatar
CHRIS ROBINANDPOOH
  • MEMBER
  • 8 POSTS
what do I do in this case ?
Mar 17, 2012 at 8:50 PM
Advertisement
Avatar
FIXITMR
  • ✓Experienced Mechanic
  • 9,990 POSTS
could be a fuse or bad connection
Mar 17, 2012 at 9:02 PM
Avatar
FIXITMR
  • ✓Experienced Mechanic
  • 9,990 POSTS
also is scanner powered or does it need port for power?
Mar 17, 2012 at 9:05 PM
Avatar
CHRIS ROBINANDPOOH
  • MEMBER
  • 8 POSTS
all fuses under dash good power block fuses all good too, unit is powering up and then reads error. whats next?
Mar 17, 2012 at 9:15 PM
Avatar
FIXITMR
  • ✓Experienced Mechanic
  • 9,990 POSTS
check engine light works?
Mar 17, 2012 at 9:21 PM
Avatar
CHRIS ROBINANDPOOH
  • MEMBER
  • 8 POSTS
I'm not sure I'll check in the morning . It was a total long block swap and it went really easy , too easy . I dont know if it helps or matters .
Mar 18, 2012 at 12:25 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.