i rebuilt the top end of my 97 ford mustang v6 engine and i have no spark. i also replace the coil pack and still no plug why dont i have a spark
Jul 4, 2011 at 9:32 PM
No spark!
HOCKEYSTAR10000
- MEMBER
- 3 POSTS
Advertisement
No snapping blue spark continue to troubleshoot the ignition system-power input to the coil/coil packs,coil's resistances,distributor pick-up coil, ignition control module, cam and crank sensors and computer Note: If it doesn't apply disregard it.
Jul 4, 2011 at 9:43 PM
Did it start up right after you finished the job? Look to see if there are any pinched/disconnected wires or grounds. Have you checked fuses?
Jul 4, 2011 at 9:45 PM
it never started u havent had spark sense rebuild, could it be a camshaft or crankshaft position sensor?
Jul 5, 2011 at 6:33 AM
i messed that up ha, i ment to say it never started sense rebuild, and yes i did check fuses and their all good and could it be a camshaft or crankshaft position sensor?
Jul 5, 2011 at 6:35 AM
Yeah that's possible, do you have use of a scanner? You can look on the data stream to see if the sensors are working properly.
Jul 5, 2011 at 10:12 AM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement
parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.