Where is the coil wier on a 97 dodge strates?
Feb 7, 2011 at 4:59 AM
coil wier
1997 DODGE STRATUS
PINKHAZE28
- MEMBER
- 3 POSTS
Advertisement
CARADIODOC
- ✓ASE Certified Mechanic
- 34,321 POSTS
There isn't one. It's built into the distributor cap.
Feb 7, 2011 at 6:15 AM
how do i dis manel it so that no one can start it/
Feb 7, 2011 at 9:10 AM
CARADIODOC
- ✓ASE Certified Mechanic
- 34,321 POSTS
Easiest way is to remove the automatic shutdown (ASD) relay. That sends voltage to the ignition coil in the distributor, and the injectors.
You can also install a switch in the wire that operates that relay or the starter relay. Disconnecting the camshaft position sensor will stop the Engine Computer from turning on the ASD relay but that will also set a diagnostic fault code in memory and turn on the Check Engine light.
I guess it all depends on what you're trying to accomplish.
caradiodoc
You can also install a switch in the wire that operates that relay or the starter relay. Disconnecting the camshaft position sensor will stop the Engine Computer from turning on the ASD relay but that will also set a diagnostic fault code in memory and turn on the Check Engine light.
I guess it all depends on what you're trying to accomplish.
caradiodoc
Feb 7, 2011 at 9:41 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.