coil

1997 DODGE INTREPID
160,000 MILES • 6 CYL • FWD
Avatar
GREG THOMPSON
  • MEMBER
  • 2 POSTS
97 dodge intrepid.. No power to the coil and no spark. Changed crank and cam shaft sensors and it still gives me a code 54. car turns over and powers up just fine and you can hear the fuel pump pressurize the system. But there is no spark. There is no voltage to the coil in the on ,off, or cranking position. The car was running fine when it just shut down. I also switched the ASD relay and still nothing.. What else should I check????
Dec 31, 2010 at 8:07 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
Follow the wiring from the coil back to the pcm to see if there is a break (open). Check it from end to end for continunity. If it is good, check the PCM for power to the coil. NOTE: It should have power in the run position and will not in the off position.
Jan 17, 2011 at 3:44 AM
Avatar
MAXWELLHART
  • MEMBER
  • 4 POSTS
i scan my pcm they are no codes what do i need to do now?
May 29, 2014 at 11:04 AM
Avatar
MAXWELLHART
  • MEMBER
  • 4 POSTS
i scan my pcm and no codes what do i need to do now?
May 29, 2014 at 11:13 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.