Its engine type is the single cam MPFI(without ABS)
Sep 3, 2011 at 11:55 PM
How much pounds to set my torque wrench for to tighten my cylinder head of my 1997 Daewoo Cielo.
1997 DAEWOO CIELO
SEAN LOKHAI
- MEMBER
- 1 POST
Advertisement
MHPAUTOS
- ✓ASE Certified Mechanic
- 31,937 POSTS
1st step 25Nm
2nd step with a degree plate turn 70 Deg
3rd step turn another 70 Deg
4th step run to normal operating temp and tighten all bolts a further 30 deg.
Note: these are torque to yield bolts and new bolts should only be used, re using old head bolts will cause the gasket to fail as they will be over stretched and will not torque down correctly.
2nd step with a degree plate turn 70 Deg
3rd step turn another 70 Deg
4th step run to normal operating temp and tighten all bolts a further 30 deg.
Note: these are torque to yield bolts and new bolts should only be used, re using old head bolts will cause the gasket to fail as they will be over stretched and will not torque down correctly.
Sep 7, 2011 at 7:58 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.