1997 CHRYSLER LHS
15,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
How do I reprogram my factory installed remote after changing the batteries?
Mar 31, 2013 at 6:11 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
CARADIODOC
  • CAR REPAIR CONTRIBUTOR
  • 34,308 POSTS
The Remote Keyless Entry (RKE) module is programmed with the Chrysler DRB3 scanner to the remotes. The remotes only produce the one signal they're built with and do not get reprogrammed. They still produce the same signal when the battery is replaced. Be sure the battery isn't installed upside-down and there's no fingerprint grease on either side.
Mar 31, 2013 at 6:21 AM
Advertisement