replacing the gasket and filter on transmission , there are 16 bolts when I drop the pan is there any spring or part that will fall into pan
Nov 16, 2010 at 12:52 PM
97 chevy tahoe
1997 CHEVROLET TAHOE
NIGLIOS
- MEMBER
- 2 POSTS
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
No. there's nothing to worry about. After you drop the pan, the filter is snapped into the valve body. (May be on bolt to remove)
Make sure to remove any o-ring with the old filter and install the new one. And scrape the gasket mating surfaces on both the tranny and pan, if needed. Don't if it doesn't.
Make sure to remove any o-ring with the old filter and install the new one. And scrape the gasket mating surfaces on both the tranny and pan, if needed. Don't if it doesn't.
Nov 16, 2010 at 12:55 PM
Advertisement
thanks
Nov 16, 2010 at 1:18 PM