1997 Chevrolet S-10 engine problems.

1997 CHEVROLET S-10
Avatar
LUNNYB86
  • MEMBER
  • 1 POST
i have a 97 s10 that i cannot get to start I've replaced map sensors, spark plugs and wires, distributor cap, and fuel pump. the truck will get fire to the plugs but will not turn over, I've also replaced the cam position sensor as well, I've tried to start it will starting fluid and the truck still will not start, your help on this would be greatly appreciated.
Mar 18, 2014 at 6:19 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
Unless the timing is off or you have very low compression, it should at least fire with starting fluid. Are you getting a good hot blue snapping spark to the plugs? Is the fuel pressure within the manufacturer's specs? Is there power to the injector system?
Mar 19, 2014 at 8:45 AM
Advertisement