how to replace rear wheel barings with disc breaks
Oct 20, 2012 at 3:06 PM
1997 Chevrolet Monte Carlo Replace Rear Wheel Barings Disc Breaks
1997 CHEVROLET MONTE CARLO
ANONYMOUS
- MEMBER
- 1 POST
Advertisement
HMAC300
- ✓ASE Certified Mechanic
- 48,601 POSTS
NOTE: Hub and bearing cannot be serviced separately.
Removal
Raise and support vehicle. Remove wheel. Remove brake caliper and wire aside. Remove brake rotor. Disconnect anti lock brake wheel speed sensor electrical harness (if equipped). Remove hub and bearing assembly
Torx bolts. Remove hub and bearing assembly. See Fig. 2 .
Installation
To install, reverse removal procedure. Tighten fasteners to specification. See TORQUE SPECIFICATIONS .
Fig. 2: Exploded View Of Hub & Bearing Assembly
Courtesy of GENERAL MOTORS CORP.
Removal
Raise and support vehicle. Remove wheel. Remove brake caliper and wire aside. Remove brake rotor. Disconnect anti lock brake wheel speed sensor electrical harness (if equipped). Remove hub and bearing assembly
Torx bolts. Remove hub and bearing assembly. See Fig. 2 .
Installation
To install, reverse removal procedure. Tighten fasteners to specification. See TORQUE SPECIFICATIONS .
Fig. 2: Exploded View Of Hub & Bearing Assembly
Courtesy of GENERAL MOTORS CORP.
Image (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Oct 20, 2012 at 3:29 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.