car cranks but wont start checked codes found bad ign lock cyl codes checked for the proper voltage at connector to switch according to the trouble tree the lock cyl needed replaced., did so then the procedure to relearn the lock code said to clear the codes then go through the 3 ten min cycle of relearn .The problem no scanner I have will clear the codes * B1014 B1024
Is there an instrument cluster problem or does it take a tech 2 to clear the code? I tried to run the relearn without clearing the code but no luck any help would be appreciated
Is there an instrument cluster problem or does it take a tech 2 to clear the code? I tried to run the relearn without clearing the code but no luck any help would be appreciated
Apr 4, 2013 at 8:03 AM
