My Audi 1997 A8 hasn't run for a while, now it starts but stops after 30 sec

1997 AUDI A8
220,000 MILES
Avatar
IOIODANI
  • MEMBER
  • 2 POSTS
When I first bought it the owner said the fuel pump and the ignition coils need to be replaced. I bought a new fuel pump from UK, I'm sure it's the right model for my car. Replacing just the fuel pump itself, not the whole assembly, was more convenient for me.
Also, I found some used low miles ignition coils on eBay, and I had them replaced.
The car still didn't run.
I recharged the battery, the car was still dead.
I went to a shop and they said the ECU is the problem. I towed the car to an Audi dealer, they replaced and reprogramed the new ECU - the car didn't start.
Now the car is back to the shop, and now I'm being told the fuel pump is a bad one, it doesn't give enough pressure.
Can this really be the problem?? I find it impossible! The fuel pump that I bought is for AUDI A8 (4D2, 4D8) 4.2 quattro,03.94 - 11.98,220kw,299HP,4172cc!
Now the car starts, but runs for only 30 seconds!
Somebody, please tell me what could be the problem??
Feb 4, 2012 at 7:47 PM
Advertisement
Avatar
RASMATAZ
  • ASE Certified Mechanic
  • 75,992 POSTS
  • ASE Certified Mechanic
Have the fuel pressure check if its within specs-start here
Feb 4, 2012 at 7:50 PM
Avatar
JACOBANDNICKOLAS
  • ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
I hope you replaced the fuel in the vehicle if it was sitting. As far as the fuel pump, if it doesn't produce enough pressure, the engine won't run. And, you can get a bad one.

Check the pressure yourself to see if it falls within the manufacturer's spec. Then you will know if it is working properly. Also, make sure the fuel filter isn't plugged.
Feb 4, 2012 at 7:53 PM
Avatar
IOIODANI
  • MEMBER
  • 2 POSTS
Thanks for the advices, guys!! Finally, the car started, it seems like there was a leak in the air intake. Unfortunately it worked just for a day. Now I can't even turn it on. I had a really bad luck with the shop where the car was checked. It's hard to trust somebody now.
The error I get right now is 18020 - engine control module incorrectly coded. I repeat: the ECU was replaced and reprogramed by dealer.
Any ideas? Thanks a lot!
Feb 16, 2012 at 3:52 AM
Avatar
RASMATAZ
  • ASE Certified Mechanic
  • 75,992 POSTS
  • ASE Certified Mechanic
Your welcome
Feb 16, 2012 at 5:53 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.