misplaced intake and exhaust cam

1996 SUBARU OUTBACK
237,000 MILES • 4 CYL • AWD • AUTOMATIC
Avatar
BRUCE64
  • MEMBER
  • 5 POSTS
I removed the top and bottom camshafts after I replaced them I restored the intake cam and the exhaust cam if I put the intake cam where the exhaust cam should be will that cause my car not to start up?

Feb 24, 2011 at 7:58 AM
Advertisement
Avatar
DOCFIXIT
  • ✓ASE Certified Mechanic
  • 18,828 POSTS
  • ASE Certified Mechanic
Well yes it would totaly different lobe profile
Feb 24, 2011 at 3:36 PM
Avatar
BRUCE64
  • MEMBER
  • 5 POSTS
are there identifling marks on the cams to correct the problem and where would they be
Feb 24, 2011 at 4:37 PM
Avatar
DOCFIXIT
  • ✓ASE Certified Mechanic
  • 18,828 POSTS
  • ASE Certified Mechanic
No I.D. marks but exhaust cam lobes are slightly larger than intake. so measure lobes to find out. need Micro or dial caliper
Feb 24, 2011 at 6:48 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.