The car just bogged down and quit. I received p0325 and p025 codes. I need some advice.

1996 SUBARU LEGACY
200,100 MILES
Avatar
BOORAY59
  • MEMBER
  • 6 POSTS
The car just turned over 200k. I have had no major toubles with it. It has had an o2 sensor code on for awhile, but had run fine. Today it bogged down slightly and just quit. It will turn over, but won't completely crank. I ran obd - It has p0325 and p0420 codes. After these codes, 3 ready - misfire, fuel, and comp. Any ides on where to begin would be helpful. What do I need to replace etc....
Thank you
Sep 20, 2011 at 9:28 PM
Advertisement
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
check your fuel pressure, attached is the correct way to do it.
Image (Click to enlarge)
Attached Media
Sep 20, 2011 at 10:28 PM
Avatar
BOORAY59
  • MEMBER
  • 6 POSTS
what about the p0325 and p0420 codes?
Sep 20, 2011 at 10:45 PM
Advertisement
Avatar
BOORAY59
  • MEMBER
  • 6 POSTS
Also - I do not have a fuel pressure guage
Sep 20, 2011 at 10:53 PM
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
i you dont' h ave a fp gauge then take it to a pro. the codes may go away once the car is running right. One is a calytic converter the other is aknock sensor but that doesn' tmean they are bad, you need to get the car running right first
Sep 20, 2011 at 10:57 PM
Avatar
BOORAY59
  • MEMBER
  • 6 POSTS
so do you figure it is the fuel pump?
Sep 20, 2011 at 11:06 PM
Avatar
BOORAY59
  • MEMBER
  • 6 POSTS
or what do you suggest if the fuel pressure is not correct? (I may be able to get a guage)
Sep 20, 2011 at 11:07 PM
Avatar
BOORAY59
  • MEMBER
  • 6 POSTS
ps - I do appreciate your help.
Sep 20, 2011 at 11:08 PM
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
if it'snot correct fix it, yourpump nmay have gone out. if it is below the spec it on't runright if at all.
Sep 20, 2011 at 11:59 PM